Crystalyte Phoenix Cruiser 3640 Electric Bicycle Conversion Kit

The Phoenix Cruiser 3640 Electric Bike Conversion Kit will comvert a typical pedal bicycle into an environmentally friendly, short diatnce commuting vehicle. With the Phoenix Cruiser 3640, cyclists do not require any confusing instructions about electrical wiring. YThe system is shipped pre-wired for painless and fast nstallation. Just replace the ordinary front wheel with the electric wheel, attach the throttle and cruise control (optional on some models) to standard handlebar, attach the power bag to the rack (rack included), plug in the connectors, and ride to  any destination.  The Phoenix Cruiser 3640 36 volt system is available on 20, 24, 26 inch front wheel and 26 inch back wheel. 

 

Not only is this kit a better option for the environment than the typical gas guzzler, but commuters reqiure no license, no insurance and have no parking problems. Ride anywhere you can ride a pedal bike. They can use the motor alone, pedal, or use both at the same time. 

Batteries and charger included. 

 

This is a complete system; nothing else to buy. Range (distance per charge) depends on many factors including tire tread pattern, tire pressure, weight of rider, wind, hills, stop-and-go, rider driving habits. Adding pedal power helps, particularly at start-up. A rider willing to do some pedaling and keep speed under 20 MPH may get 25 or more miles on a charge. As with a car, the faster you take-off and the faster you run, the more fuel per mile you will use. Crystalyte kits include an electric motor mounted in the hub of the wheel, speed controller, key switch, connectorized wiring, fuse, batteries, charger, throttle with gauge (thumb or twist - your choice), wire ties, rack, battery bag, cruise control, brake inhibits. There is nothing else to buy. The entire kit comes pre-wired. There are three motors in the Phoenix Series. They are all brushless motors and are the same physical size. They can be used with either 36 volt (3640) or 48 volt 40 amp (4840) controllers. Phoenix front motors are available on 20 inch, 24 inch, 26 inch, and 700c wheels. Rear 7-speed wheels are available in 26 inch. Other rear wheel sizes available by special order. Dropout width is 100mm for front wheels and 135mm for rear 7-speed wheels. The axle is 9mm in diameter. Phoenix motors are 75 mm wide, extending 100 mm up the fork from the axle. Weight is 23.5 pounds laced to the rim.  The Phoenix is the most powerful motor available for a bike. This system exceeds power and speed limits established by the federal law that defines a bicycle, so ride on-road at your own risk. Choose a bike with good brakes, inspect them often, and replace worn shoes or pads as needed. You'll be putting a lot more miles on an electric bike than a pedal bike, and brakes become very important at the speeds you will reach.